What are the precautions for Qingling Isuzu accessories? We have made a brief introduction to this issue before, but found that many customers still don't understand it. It just so happens that today I will take this opportunity to explain it to you. I hope it can bring good help to the relevant people.

    There are also many things to pay attention to when using Qingling Isuzu accessories. For example, if the Qingling Isuzu accessories are improperly adjusted by the cylinder and pedal; the bearing leaks or fails; the bearing sleeve is stuck; the separation is cracked and deformed, etc., it will fail or malfunction in a very short time, and even cause car accidents and personal accidents. Another thing everyone should pay attention to is that the performance of their pressure plate assembly, driven plate assembly and notarized bearing assembly are interrelated. Once an assembly fails or is damaged, it will cause gasket damage to the other two assemblies. Please users (maintenance personnel) pay attention to the distinction, avoid any failure or any of their own assemblies, and replace them together with the three assemblies to avoid unnecessary maintenance and "return" costs. Or the service life of Qingling Isuzu accessories under normal use conditions, the pressure plate assembly is not less than 50,000 kilometers, and the driven plate assembly is not less than 30,000 kilometers. Causes and solutions to the problem

    When Qingling Isuzu parts are stained with oil or rust, they should be disassembled to remove the oil stains, cleaned with gasoline or kerosene, and then installed after drying. Secondly, it is also recommended to apply an appropriate amount of butter after cleaning or replacing the clutch bearing, and do a good job of the dust cover facing the clutch side, and do not install it back to prevent the oil from flowing onto the clutch and causing the clutch to slip. When using, the operating mechanism should be adjusted regularly, the mud should be cleared, all connecting bolts should be tightened, and the pedal shaft of Qingling Isuzu parts should be lubricated as required. Or between the spiral bevels of its bearing cover, it should be frequently cleaned and lubricated with engine oil or butter, and the engine oil should be frequently dripped into the small oil hole on the separation claw to lubricate the separation claw and the separation claw seat. When using Qingling Isuzu parts, it is mainly for long-term open work and poor lubrication conditions. Therefore, after the tractor has worked for 300 to 500 hours, the separation bearing should be removed, cleaned with diesel, and rotated flexibly. Put it in a container filled with butter and heat it until the butter fills the bearing, and take it out after cooling and solidification. As the flagship product of our factory, we thank new and old customers for their strong support. While ensuring the reliability of product quality, we also benefit our customers. If you have any technical questions about the product, you can come here to consult at any time.

    After the above introduction, we also have a further understanding of the precautions for Qingling Isuzu accessories. You will not feel unfamiliar when you see it again in the future, and there will be no frequent problems during use. Well, today's content is here, I believe it will bring more exciting knowledge points.